Perfect tips 1x2 4 watt
Previous Close.0150, open.0076, bid.0000 x 0, ask.0000 x 0, day's Range.0076 -.0355 52 Week Range.0016 -.0550.Volume 48,761, market Cap.273M, beta (5Y Monthly).19, pE Ratio (TTM n/A.EPS (TTM) -0.0030, earnings Date, n/A, forward Dividend Yield, n/A (N/A).Ex-Dividend Date, n/A 1y Target Est, n/A.JQ Green America Brand Flame Tip Candelabra Base Bulb with Edison style LED filaments.
Specifications 120 Volts 4 Watts/360 Lumens Dimmable 2700 K Color Temp, e-12 Candelabra Base 15,000 Hour Lifespan, dry Location Use Only.Imported, only logged in customers who have purchased this product may leave a review.Finger joints provide face- or edge-grain gluing surfaces to end-to-end joints for a stronger glue bond.Any joint that butts end grain to end grain will be weak because you're gluing wood fibers at their porous ends instead of along their sides.(Picture trying to glue two drinking straws together at their ends instead of along their sides.) Fortunately, you can strengthen end-to-end joints for those rare occasions when they're necessary, such as connecting two pieces of crown.Boiled down to basics, you must either add reinforcements, such as plates, dowels, or screws, or cut the joint in a way that creates mechanical strength and exposes more face or edge grain for a stronger bond, such as the.
Check out these eight solutions, from basic to beautiful.Plain, practical straps, use simple metal or plywood straps to reinforce butt joints where they can be hidden or where appearance isn't important, such as on the back side of a wide crown molding where you can't afford any waste.Making your own custom-sized straps from 14 " plywood saves you money and provides a strong gluing surface.To install a wooden strap, cut it as wide as the workpiece allows.If you're joining pieces with a profile on the opposite face, such as molding, locate the screw holes over the thickest profile pointsat the peak of a ridge or curve, for example.
To make the joint, glue and screw one side of the strap to a workpiece.After the glue dries, glue the other half of the strap, and clamp the assembly to a flat surface.For a tight joint, raise the other workpiece about 14 " at 3' from the end being jointed.